Diseqc Motor3/29/2021
Works with all DiSEqC 1.2, 1.3, USALS or Goto X compliant receivers.The motor is ideal for dishes up to 95cm in size (22LBS in weight).
Historically, motors have been better suited for the European style dish-mounts, which utilize U-bolts to attach to the mounting pole. The HH90 motor can be easily installed with both European style and North American style dish-mounts. This means consumers can buy the HH90 motor with confidence knowing that it will be compatible with their dish up to 95cm in size.Of course, the HH90 motor also uses STABs proprietary USALS technology making installation easy and reliable. All of our receivers are compatible with the USALS standard.Once the satellite positions have been programmed in the system, the STAB HH Motor returns the dish to exactly the correct location when you switch channels.NOTE: Tighten all the coaxial cable connections only by hand. It utilizes a data stream passed up the LNB co-axial lead to the mount. Only one co-axial cable (the one that goes to the LNBF) is needed for installation. Maxintelligence precision calibration allows the motor to go to the satellite accurately every time. Then run a short coaxial cable between the motor and the LNBF. Make sure to turn the receiver OFF whenever you disconnect or connect the coaxial cable to the motor or LNBF. All receivers compliant with the DiSEqC 1.2, 1.3, or USALS protocol have the capability to run an HH motor. Once you initially setup the motor on the satellite arc and store the locations of the satellites, you will be able to move between satellites by simply changing the channel. In some cases, it is best to use RG11 coaxial cable for longer runs. Also, bad quality connectors may rust or cause moisture to get in. In the case of Satcontrol motor, it will move all the way to East then move to 0-position. Any leaning of the mast one direction or another will cause the motor not to track the ARC correctly. Use a good compass to aim your motordish assembly to correct direction. Adjust dish elevation Up or Down from calculated value no more than one degree at a time. Heavier dishes will cause much strain on the motor and eventually it may damage the internal gears of the motor or burn the motor. That way you will gain many more channels economically without investing in many dishes and switches.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |